Odrive V3.4 driver
Turnigy Aerodrive SK3 - 4250-410KV Brushless Outrunner Motor
ENCODER PROG 16RES SW TTL RADIAL
30 tooth GT2 pulley 6mm belt
24 V 10 A UPS
SPDT Mini Snap Switch with Roller(homing)
I need an Arduino sketch that will allow me to run a +/-10 oz load over a length = 1000 mm (or less)
Speed = Max Speed
The load must run back and forth at max speed over a single x-axis at current distance of 1000 mm. (or less) .The current distance can be increased or decreased based on needs; clear instructions to modify parameters (distance, speed, acceleration,etc) must be provided if length is changed.
Homing must be configured.
At all times, I need to know exact position (step) where step motor is at at .
Any other piece of data as speed,acceleration, temp that can be supplied with code will be useful.
Code must have good notes, otherwise will be rejected.
Hours to be determined
Less than 1 month< 1 monthProject LengthDuration
I am looking for freelancers with the lowest rates