DXF Endpoint errors - Need fixing - DXF or Solidworks file

Engineering & Architecture 3D Modeling & CAD Posted 2 years ago


Hours to be determined
Less than 1 week

Intermediate Level

Start Date

April 29, 2014


I have a DXF file (also Solidworks part file) that needs to be laser cut. The laser cutter has informed me there are end point errors. He has advised me there is about 2 hours work cleaning up these errors to get them ready for the laser cutter.

His message is as follows:

"Too many end pt errors in your program , will need to spend at least an 2 hr to clean up

See below in red and yellow , each circle indicates errors .

Lines need to be a close contour ie :  each line needs to be joint with each other .. no gap or double lines or overlaps"

Please refer to the reference image.

Freelancer must supply the .DXF file with errors fixed and suitable for laser cutter to run.

Please contact me if you have any questions.

I  can supply .DXF and Solidworks Part file.

  • Other Skills:

Activity on this Job

Last Viewed by Client: 2 years ago

Invites Sent: 0

Unanswered Invites: 0

Hired: 1

Other open jobs by this client ({{ jobsCount }})

About the Client

(5.00) 45 reviews

Melbourne 04:33 AM

89 Jobs Posted
59% Hire Rate, 1 Open Job

$3,452 Total Spent
57 Hires, 1 Active

$6.61/hr Avg Hourly Rate Paid
34 Hours

Member Since Nov 21, 2010