We are looking to hire someone to calculate linear square feet of cabinets and square feet of countertops for apartment buildings. The information will be provided in architectural plans. You would need to look at plans and determine which kitchen and bath goes in which unit.
See two attached folders ACP set 1 of 2 and 2 of 2.
Please pick two units (does not matter which ones) and tell me total linear feet of cabinets and total square feet of countertops (total for bathrooms and kitchen.
You will need to go to ACP 1 of 2 to find plan view to determine which kitchen and bathrooms goes into which specific unit. You will then need to go to ACP 2 of 2 to find the kitchen and bathrooms in said units. Then send the results.
To calculate LF of cabinets you add up total cabinet length in inches (the kitchen and baths and pantries) then divide by 12 to get Linear Feet for that unit (cabinets needed where there is dishwasher or a stove, but usually a cabinet above refrigerators).
To get square feet of countertops you need to add the length in inches (you would include above dishwasher, always 24", but not above stove) multiply by the depth then divide by 144 to get square feet. In the kitchen use 24" depth where tops/cabinets are against the wall. If corner in the kitchen/tops then you will need to add 27" for the corner. Please note these units have islands so you will need to determine the depth of the island. Then again you would take the depth of island times the length divided by 144. In the bathrooms the depth is 21", in these units there is a 3" backsplash in bathrooms only (not in kitchens) so you would add that to the depths. So in the bathrooms you would take total length in inches times 24" (21" depth plus 3 inch backsplash) divided by 144 to get square feet. You would then provide the total kitchen and bath square feet of countertops.
We would also like for you to count doors and drawers in the unit.
Example of what I want back from you is -
UNIT TYPE A1.0, TYPE B LF OF CABINETS 33.43, SF OF TOPS 52.69, 20 DOORS, 13 DRAWERS.
JUST PICK PNE OR 2 UNITS SO WE CAN CHECK WORK.
Hours to be determined
More than 3 months3+ monthsProject LengthDuration
I am looking for a mix of experience and value