Model - the surface which two jets of water fall on.
It is required to determine(develop) the model of the surface, which will meet the following conditions:
- cause the minimum amount of splashing(jumping out of water droplets) at any point on the surface, but most of all in the center. Calculate this in "realflow", its analog or other way you prefer.
- be within the limitations 15х15х15 cm, but it is desirable that position of surface is arranged as it's shown on the example (DWG-file).
Expected type of material: plastic (ABS).
Two water jets are marked in green. The diameter of the jet is about 5 mm, speed - 200 cm/sec.
Result - the model, description of the model and calculation (in best case) or explanation why this surface is in compline with requirements. If you can offer several variants of surface it would be great.
I'm ready to answer any specific questions.