You've landed at the right place. oDesk is now Upwork. Learn about the new platform.

Eagle Pcb Jobs

2 were found based on your criteria

Fixed-Price - Est. Budget: $ 120 Posted
I am looking for someone with PCB Design experience as well as Arduino programming experience. I want to design a 2.4ghz RC Transmitter & Receiver setup. The transmitter will be enclosed with a 3D printed enclosure as well as receiver. I need someone to design the PCB schematic as well as help build it with arduino + program it. A few features that the controller will have are the following: - Lipo battery pack for charging - Can be charged via USB - small handheld controller - programmed in arduino - built in led lights front/rear - cruise control - slow, fast, expert options - 13mph, 20mph, aggressive throttle - option for antennas - no dropping or interference - braking turns on red lights I am ready to start on this project ASAP.

Fixed-Price - Est. Budget: $ 500 Posted
Need to design a high speed counting circuit to detect the time difference between two separate signal pulses with 1nsec resolution. The leading edge of signal 1 pulse should start the count cycle, and the leading edge of signal 2 pulse should terminate the count cycle. Please advise on most appropriate design. I have been envisioning synchronous counters clocked at 1 Ghz with a total of 32 bits, which could pass data through shift register(s) for transfer of data to unknown interface (possibly FPGA). Counting cycle could be enabled with signal from a latching comparator, and disabled by the signal of an additional comparator. Once the count is collected, the cycle is reset for the next set of pulses. I have data sheets of circuit components that may work but am uncertain if they are the most appropriate selections. Deliverable includes selection and refinement of circuit components with associated BOM, generated circuit schematics, and associated PCB layout files. Phase 1 - Select...