Custom PCB to Fit Enclosure

I am looking for an experienced PCB designer to design a production-ready PCB for a smart plant moisture monitoring product. Project Requirements The PCB must fit inside my existing enclosure, which will be provided as a .STEP file. Component placement is important, and the PCB must align with the enclosure, mounting points, buttons, screen opening, USB-C port, and all connector locations. The PCB must also be designed to fit my existing 1.54" TFT SPI display, which connects using a 10-pin 0.5 mm pitch FPC ribbon cable. Hardware Requirements ESP32 30-pin development board (plugs into female headers; the ESP32 is NOT integrated onto the PCB) 1.54" SPI TFT display 10-pin 0.5 mm FPC connector for the TFT Capacitive soil moisture sensor connector JST-PH 2-pin connector for a 3.7V 500mAh LiPo battery USB-C charging circuit for the LiPo battery USB-C connector for charging Three tactile push buttons Required voltage regulation, charging IC, protection circuitry, filtering, and decoupling components Proper mounting holes if needed for the enclosure TFT Connector Pinout 10-pin FPC (0.5 mm pitch) SDA SCL D/C RESET CS GND VCC (2.8–3.3V) LEDK LEDA GND Connectors Please include the following connectors: 2 × 15 female headers for the ESP32 30-pin development board 10-pin 0.5 mm FPC/ZIF connector for the TFT display JST-PH 2-pin connector for the LiPo battery Connector for the capacitive soil moisture sensor (to match the sensor that will be provided) USB-C receptacle for charging Deliverables Complete schematic PCB layout Manufacturing-ready Gerber files Bill of Materials (BOM) Pick-and-place file Source design files PDF schematic Assembly drawings Additional Notes The design is intended for commercial production. The PCB must fit perfectly inside my supplied enclosure. Component placement should be optimized for manufacturing and assembly. Please use commonly available components whenever possible. If you recommend any improvements to reliability, manufacturability, or cost, discuss them before making changes. Please include examples of previous PCB designs, especially products involving ESP32, USB-C charging, LiPo batteries, or TFT displays.