Kansas-licensed PE for Foundation Drawings

We are seeking a Kansas-licensed Professional Engineer to review and stamp foundation drawings. This is a basic project with a simple goal -- get a PE stamp from a Kansas-Licensed PE on documents already drawn up. I can send you the drawings. Hoping for quick turnaround. Basically, the project consists of modular compute container units sitting on two slabs, one slab at each end of the container, with each slab being a monolithic pour with four columns going into the ground. Two slabs will support one modular compute container (one slab on each end, two slabs total per modular unit). The modular units were manufactured from standard shipping containers; these end slabs for the modular container units are 8 inches thick, with rebar, and the four auger holes go down below grade 36 inches, and the auger holes will also have concrete and rebar; the rebar in the slab is 18 inches on center for the modular end slabs. The transformer pad is designed with 12-inch concrete slab, also with four auger holes with rebar and concrete, 12-inches on center, and also goes down 36 inches below grade for the auger holes. Basically, its slab on grade, monolithic pour with auger holes down 36 inches below grade, with rebar - very basic. Hoping for a quick turn around. Inquire, and I'll send you the drawings, and hopefully this can be a quick turnaround for you and me. Message me and I will share the files with you. I have 8 pdf files, that's it. 8 pdf files: Mod_SideView.pdf Mod_AugerHoleView.pdf Mod_BirdsEyeView.pdf Mod_FrontView.pdf TfmrPad_BirdsEyeView.pdf TfmrPad_SideView.pdf TfmrPad_FrontView.pdf TfmrPad_AugerHoleView.pdf