PCB Layout & Gerber Generation for 433 MHz RF Transceiver (EasyEDA)

Project Description: I am looking for an experienced hardware and PCB layout engineer to design a precise board from my completed EasyEDA schematic and generate the final Gerber files for manufacturing. Project Context & Hardware: The circuit is a 433 MHz RF transceiver built around the CC1101 chip. The system handles a 50 kbps data rate and interfaces with an ESP32 and an I2C LCD module. The RF output connects via an SMA edge connector to a 2.2 dBi monopole antenna. Key Requirements: You must have proven experience with RF board layout. Strict 50-ohm impedance control is required for the trace between the balun (0433BM15A0001001E) and the SMA connector. Proper ground plane design and stitching vias to ensure signal integrity and minimize noise. Design for Manufacturing (DFM) checks to ensure it can be easily fabricated by standard houses (like JLCPCB or PCBWay). Deliverables Needed: Fully routed PCB source files ( open to Altium/KiCad if you recreate the schematic). Final Gerber files and NC Drill files. Bill of Materials (BOM) and Pick-and-Place/CPL files.