WLED ESP32 Configuration — GPIO Current Sensor Preset Switching for Commercial LED Install

I have a commercial permanent LED lighting installation using a QuinLED Dig-Quad controller running WLED firmware with WS2811 12V pixel nodes and WS2815 Strips. I need help configuring the following: 1. Initial WLED setup — 4 output channels configured for WS2811 12V nodes with correct pixel counts per channel 2. Two presets configured — Preset 1 is color effects for normal operation, Preset 2 is solid white for when bays are in use 3. GPIO input configuration for 5 independent bay triggers — each bay has a current sensor with relay module output that sends a clean digital on/off signal to a GPIO pin on the QuinLED. When signal is HIGH lights switch to white preset for that bay, when LOW lights return to color effects 4. Macro configuration so all 5 bays trigger independently without affecting each other 5. Upon completion a written configuration document must be provided detailing every setting, GPIO pin assignment, preset number, macro configuration, and step by step instructions for reconfiguring the system in the future if needed. This document is a required deliverable for payment to be released. I am looking for someone to walk me through the entire configuration via video call or provide detailed step by step written instructions with screenshots. This is a remote job, no travel required. The configuration session itself should take no longer than 1-2 hours via video call. Written documentation deliverable expected within 24 hours after the session Must have hands on WLED experience specifically with GPIO inputs, preset configuration, and macro setup. Please describe your WLED experience in your application.