You will get performance evaluation of Texas Instruments' 77 GHz mmwave sensor modules
Top Rated
Top Rated
Project details
Texas Instruments IWR1443BOOST/IWR1642BOOST 77 GHz mmwave sensor modules have been characterized based on hardware configurations with focus on the following goals:
1. Experimentations with the radar modules to collect data sets for various target location scenarios
2. MATLAB data processing for range-doppler, range-angle and micro-doppler spectrogram plots
3. Evaluation of functional capabilities of the boards based on hardware capabilities (for instance MIMO Tx/Rx setup)
4. Brief documentation on the hardware and software required
1. Experimentations with the radar modules to collect data sets for various target location scenarios
2. MATLAB data processing for range-doppler, range-angle and micro-doppler spectrogram plots
3. Evaluation of functional capabilities of the boards based on hardware capabilities (for instance MIMO Tx/Rx setup)
4. Brief documentation on the hardware and software required
Testing Platform
Software TestingDevice
PCLanguage
EnglishWhat's included
| Service Tiers |
Starter
$50
|
Standard
$150
|
Advanced
$300
|
|---|---|---|---|
| Delivery Time | 3 days | 4 days | 5 days |
Number of Revisions | 2 | 2 | 3 |
Test Scenario | - | - | - |
Summary Report | - | - | - |
Annotated Screenshots | - | - | - |
Test Desktop | - | - | - |
Test Mobile | - | - | - |
Optional add-ons
You can add these on the next page.
Fast Delivery
+$10 - $30
39 reviews
(39)
(0)
(0)
(0)
(0)
This project doesn't have any reviews.
SC
Shane C.
Aug 22, 2026
PCB design (npn/pnp)
SC
Shane C.
Jul 15, 2026
Design a small 2-layer signal/power PCB — 5 V→12 V boost + optocoupler
RR
Ronya R.
Jun 27, 2026
30 minute consultation
EK
Emil K.
Jun 20, 2026
Antenna Design for AWR2944PEVM Board
WB
Wronald Scott B.
Jun 7, 2026
Redesign and Optimization of Offset Stripline Wilkinson Divider and Bandpass Filter
About Maryam
Electronic | DC | RF | sub-GHz | IoT | LoRa | mmwave | Antenna I EM
100%
Job Success
Karachi, Pakistan - 2:23 am local time
- Experience in the design, development and Integrated testing of a wide spectrum RF and microwave modules from 1 MHz to 10 GHz
-Solid State Power Amplifiers (Pulsed/CW), Transceivers, Low Noise Amplifiers , Digital phase-shifters/attenuators
-Impedance matching, microwave filter, circulators/isolators, directional coupler, high-power divider/combiner.
-Comprehensive performance evaluation of IWR1642 and IWR1443 Single-Chip 76-to-81GHz mmWave Sensor Integrating DSP and MCU Automotive Radar Evaluation Module with ADC data capture in DCA1000EVM with MATLAB processing
-Analog electronics , DC power management boards design, prototyping and troubleshooting
-Experience with RF measurement instruments including spectrum analyzers, Signal Generators and Vector Network Analyzer (VNA)
-2D RF/EM Analysis: Keysight Advanced Design System (Momentum, RF Pro, EMPro), Keysight Genesys
-RF link budgeting : Keysight systemVue
-3D Modelling and High Frequency Simulations : HFSS, CST microwave studio
-PCB Design and Circuit Simulations: Altium Designer/KiCAD/EasyEDA/Eagle/LTspice
-MCUs : ESP32/TMS320F/PIC16F/PIC18F/Arduino etc
-Programming languages: MATLAB , Python
-Technical writing : Overleaf, Online LaTeX Editor
-Video Editing : MAGIX Vegas Pro
Steps for completing your project
After purchasing the project, send requirements so Maryam can start the project.
Delivery time starts when Maryam receives requirements from you.
Maryam works on your project following the steps below.
Revisions may occur after the delivery date.
Performance evaluation of mmwave sensor module
Sensor calibration, raw adc data capture in controlled environment and data processing in MATLAB to get the desired range-doppler-angle information of the target of interest.